Endress+Hauser cerabar S - Page 164

Appendix Cerabar S/Deltabar S
164 Endress+Hauser
P01-xMx7xxxx-19-xx-xx-xx-044
*
*
*
**
*
SEL. DISPLAY VAL.
TANK DESCRIPTION
LINE-NUMB
DISPLAY
ALTERNATE DATA
DISPLAY CONTRAST
MENU DESCRIPTOR
MAIN DATA FORMAT
LANGUAGE
Editor Table
Measuring
Table
EXTENDED SETUP
Pressure
TEMP. ENG UNIT
Level
ADJUST DENSITIY
TEMP. ENG UNIT
PROCESS DENSITY
Flow
LOW FLOW CUT-OFF
SET L. FL. CUT-OFF
TEMP. ENG UNIT
EDITOR TABLE
TANK CONTENT MIN
TANK CONTENT MAX
TABLE SELECTION
LIN. EDIT MODE
TANK DESCRIPTION
TOTALIZER SETUP
RESET TOTALIZER 1
TOTALIZER 2 UNIT
TOTALIZER 1 UNIT
FACT. U. U. TOTAL.1
NEG. FLOW TOT. 1
TOT. 2 USER UNIT
FACT. U. U. TOTAL. 2
NEG. FLOW TOT. 2
TOT. 1 USER UNIT
LINEARISATION
Level measuring
mode only
Flow measuring
mode only
(Deltabar S only)
X-VAL.
Y-VAL.
LINE-NUMB
ACTIVE LIN. TAB. X
ACTIVE LIN. TAB. Y
TAB. ACTIVATE
There are parameters that are only displayed if other parameters are
appropriately configured.
For example the TOT. 1 USER UNIT parameter is only displayed
if the "User unit" option was selected for the TOTALIZER 1 UNIT parameter.
These parameters are indicated with a "*".