Safety instructions Gammapilot M FMG60 with FOUNDATION Fieldbus
4 Endress+Hauser
1 Safety instructions
1.1 Designated use
The Gammapilot M is a compact transmitter for non-contact level, level limit, density and
concentration measurement. The measuring range of a single Gammapilot M extends up to 2 m.
Large measuring ranges of any size can be implemented, however, by cascading several
Gammapilot M devices.
1.2 Installation, commissioning, operation
The Gammapilot M is fail-safe and is constructed to the state-of-the-art. It meets the appropriate
standards and EC directives. However, if you use it improperly or other than for its designated use,
it may pose application-specific hazards, e.g. product overflow due to incorrect installation or
configuration. Installation, electrical connection, startup, operation and maintenance of the
measuring device must therefore be carried out exclusively by trained specialists authorized by the
system operator. Technical personnel must have read and understood these Operating Instructions
and must adhere to them. You may only undertake modifications or repair work to the device when
it is expressly permitted by the Operating Instructions.
1.3 Hazardous area
Measuring systems for use in hazardous environments are accompanied by separate "Ex
documentation", which is an integral part of these Operating Instructions. Strict compliance with
the installation instructions and ratings as stated in this supplementary documentation is mandatory.
• Ensure that all personnel are suitably qualified.
• Measuring point requirements with regard to measurement and safety must be observed.
#
Warning!
Depending on the certificate version observe the associated Safety Instructions (→ ä 102).
#
Warning!
The three screws, connecting the pipe housing
to the compartment housing, must not be
opened.
L00-FMG60xxx-05-00-00-xx-052
To Next Page
Loading...
