Maintenance and repairs Gammapilot M FMG60 with FOUNDATION Fieldbus
88 Endress+Hauser
7.5 Return
The following procedures must be carried out before a transmitter is sent to Endress+Hauser e.g.
for repair or calibration:
• Remove all residue which may be present. Pay special attention to the gasket grooves and crevices
where fluid may be present. This is especially important if the fluid is dangerous to health, e.g.
corrosive, poisonous, carcinogenic, radioactive, etc.
• Always enclose a duly completed "Declaration of contamination" form (a copy of the “Declaration
of contamination” is included at the end of these Operating Instructions). Only then can Endress
+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EN 91/155/EEC.
Additionally specify:
• The chemical and physical characteristics of the product.
• An exact description of the application.
• A short description of the error that occurred (specify error code if possible)
• Operating time of the device.
7.6 Disposal
When disposing, separate and recycle the device components based on the materials.
7.7 Contact addresses of Endress+Hauser
Contact addresses can be found on our homepage: www.endress.com/worldwide. If you have any
questions, please contact your Endress+Hauser subsidiary.
To Next Page
Loading...
