Endress+Hauser Gammapilot M FMG60 - Switching on the Device

Commissioning Gammapilot M FMG60 with FOUNDATION Fieldbus
62 Endress+Hauser
6.2 Switching on the device
⇒
FMG60
V01.01.06 FF
After switching on the supply voltage, the device is first initialized.
Due to internal memory tests, this takes approx. 2 minutes. Then,
the following appear for approximately five seconds:
• Device type: FMG60
• Software version: Vxx.yy.zz
– xx: hardware version
– yy: software version
– zz: software revision
• Type of the communication signal:
–HART
– PA: PROFIBUS PA
– FF: FOUNDATION Fieldbus
ENDRESS + HAUSER
E
+
–
⇒
Language 092
ÂEnglish
Français
Español
On first power-up you are requested to select the language for the
display texts.
Select the language with the O and S keys.
Confirm your choice by pressing F twice.
ENDRESS + HAUSER
E
+
–
⇒
Measured
value 000
63.4 %
ÊÊÊÊÊÊÊÊÊÊÊ
After that the measured value display appears.
Press F to switch to the group selection.
ENDRESS + HAUSER
E
+
–
⇒
Group selection
Âbasic setup
calibration
safety settings
The "basic setup" function group is already selected.
Press F to enter the first function of this function group.
ENDRESS + HAUSER
E
+
–