Endress+Hauser Gammapilot M FMG60 - FOUNDATION Fieldbus interface

Gammapilot M FMG60 with FOUNDATION Fieldbus Operation
Endress+Hauser 39
5.6 FOUNDATION Fieldbus interface
5.6.1 System architecture
The following diagram shows two typical examples of a FOUNDATION Fieldbus network with the
associated components.
L00-FMxxxxxx-14-00-06-xx-001
Fig. 3: FOUNDATION Fieldbus-HSE: High Speed Ethernet, FOUNDATION Fieldbus-H1: FOUNDATION Fieldbus-
H1, LD: Linking Device FOUNDATION Fieldbus-HSE/FOUNDATION Fieldbus-H1,
PS: Bus Power Supply, SB: Safety Barrier, BT: Bus Terminator
The system can be connected in the following ways:
– A linking device makes the connection to higher-order fieldbus levels (e.g. High Speed Ethernet (HSE)) possible.
– A FOUNDATION Fieldbus-H1 connecting card is needed for direct connection to a process control system.
!
Note!
Further information on FOUNDATION Fieldbus can be found in Operating Instructions BA013S
"FOUNDATION Fieldbus Overview, Installation and Commissioning Guidelines", the
FOUNDATION Fieldbus Specification or on the Internet at "http://www. fieldbus.org".
ENDRESS + HAUSER
Micropilot M
Prosonic M
LevelflexM
ENDRESS + HAUSER
E
+–
%
T
PROFIBUS DP
PROFIBUSPA
• ToF Tool - FieldTool Package
•FieldCare
-Profiboard/Proficard
SPS / PLC / API
VU331
• ToF Tool - FieldTool Package
•FieldCare
1
FHX40
VU331
Gammapilot M
VU331
•FXA291/ToF Adapter FXA291
•FXA193