Endress+Hauser Micropilot FMR56 - Page 155

Micropilot FMR56, FMR57 FOUNDATION Fieldbus Operating menu
Endress+Hauser 155
level change during operation. Signals which are already in the blocking distance when the
device is switched on, are ignored.
This behavior is only valid if the following two conditions are met:
• Expert → Sensor → Echo tracking → Evaluation mode = Short time history or Long
time history)
• Expert → Sensor → Gas phase comp. → GPC mode= On, Without correction or
External correction
If one of these conditions is not met, signals in the blocking distance will always be
ignored.
If required, a different behavior for signals in the blocking distance can be defined by
the Endress+Hauser service.
BD
A0023041
 38 Blocking distance (BD) for bulk solid measurements