Endress+Hauser Micropilot FMR56 - Assign Limit; Assign Diagnostic Behavior

Micropilot FMR56, FMR57 FOUNDATION Fieldbus Operating menu
Endress+Hauser 157
• Digital output 2
• Digital output 3
• Digital output 4
• Digital output 5
• Digital output 6
• Digital output 7
• Digital output 8
Factory setting Off
Additional information The Digital output AD 1 and Digital output AD 2 options refer to the Advanced
Diagnostic Blocks. A switch signal generated in these blocks can be transmitted via the
switch output.
Assign limit 
Navigation  Setup → Advanced setup → Switch output → Assign limit
Prerequisite Switch output function (→  156) = Limit
Description Select process variable for limit monitoring.
Selection • Off
• Level linearized
• Distance
• Terminal voltage
• Electronic temperature
• Relative echo amplitude
• Area of incoupling
Factory setting Off
Assign diagnostic behavior 
Navigation  Setup → Advanced setup → Switch output → Assign diag. beh
Prerequisite Switch output function (→  156) = Diagnostic behavior
Description Select diagnostic behavior for switch output.
Selection • Alarm
• Alarm or warning
• Warning
Factory setting Alarm