Endress+Hauser Micropilot FMR56 - Ramp at Echo Lost

Operating menu Micropilot FMR56, FMR57 FOUNDATION Fieldbus
154 Endress+Hauser
Ramp at echo lost 
Navigation  Setup → Advanced setup → Safety sett. → Ramp echo lost
Prerequisite Output echo lost (→  153) = Ramp at echo lost
Description Define the slope of the ramp in the case of a lost echo.
User entry Signed floating-point number
Factory setting 0.0 %/min
Additional information
t
min
0%
100%
A
B
C
A0013269
A Delay time echo lost
B Ramp at echo lost (→  154) (positive value)
C Ramp at echo lost (→  154) (negative value)
• The unit for the slope of the ramp is "percentage of the measuring range per minute" (%/
min).
• For a negative slope of the ramp: The measured value is continuously decreased until it
reaches 0%.
• For a positive slope of the ramp: The measured value is continuosly increased until it
reaches 100%.
Blocking distance 
Navigation  Setup → Advanced setup → Safety sett. → Blocking dist.
Description Specify blocking distance BD.
User entry 0 to 200 m
Factory setting FMR56, FMR57: antenna length + 400 mm (15.7 in)
Additional information Signals in the blocking distance are only evaluated if they have been outside the blocking
distance when the device was switched on and move into the blocking distance due to a