Endress+Hauser Micropilot FMR56 - Structure and Function of the Operating Menu; Structure of the Operating Menu

Operation options Micropilot FMR56, FMR57 FOUNDATION Fieldbus
46 Endress+Hauser
8.2 Structure and function of the operating menu
8.2.1 Structure of the operating menu
Menu Submenu /
parameter
Meaning
Language
1)
Defines the operating language of the
on-site display.
Setup Parameter 1
...
Parameter N
When all these parameters have been
assigned appropriate values, the
measured should be completely
configured in a standard application.
Advanced setup Contains further submenus and
parameters:
• to adapt the device to special
measuring conditions.
• to process the measured value
(scaling, linearization).
• to configure the signal output.
Diagnostics Diagnostic list Contains up to 5 currently active error
messages.
Event logbook
2)
Contains the last 20 messages (which
are no longer active).
Device information Contains information needed to identify
the device.
Measured values Contains all current measured values.
Data logging Contains the history of the individual
measuring values.
Simulation Used to simulate measured values or
output values.
Device check Contains all parameters needed to check
the measurement capability of the
device.
Heartbeat
3)
Contains all wizards for the Heartbeat
Verification and Heartbeat Monitoring
application packages.
Expert
4)
Contains all parameters of the device
(including those which are already contained
in one of the above submenus). This menu is
organized according to the function blocks of
the device.
The parameter of the Expert menu are
described in:
GP01017F (FOUNDATION Fieldbus)
System Contains all general device parameters
which do not affect the measurement or
the communication interface.
Sensor Contains all parameters needed to
configure the measurement.
Output Contains all parameters neeed to
configure the switch output (PFS).
Communication Contains all parameters needed to
configure the digital communication
interface.
Diagnostics Contains all parameters needed to
detect and analyze operational errors.
1) In case of operation via operating tools (e.g. FieldCare), the "Language" parameter is located at "Setup →
Advanced setup → Display"
2) only available with local operation
3) only available for operation via DeviceCare or FieldCare
4) On entering the "Expert" menu, an access code is always requested. If a customer specific access code has
not been defined, "0000" has to be entered.