Endress+Hauser Proline Prowirl 73 - Page 113

Proline Prowirl 73 Description of device functions
Endress+Hauser 113
ASSIGN LINE 2 Description
For assigning a display value to the additional line (bottom line of the local display).
This value is displayed during normal operation.
• The appropriate unit is selected in the SYSTEM UNITS group (ä 102).
• Totalizer 1 is indicated on the local display by "I" and totalizer 2 by "II".
• The CALCULATED SATURATED STEAM PRESSURE option only appears if
SATURATED STEAM was selected in the SELECT FLUID function (ä 143).
• The TEMPERATURE (EXTERNAL) option only appears if TEMPERATURE or
TEMPERATURE 72 was selected in the HART INPUT function (ä 167).
• The PRESSURE (EXTERNAL) option only appears if PRESSURE or PRESSURE 72 was
selected in the HART INPUT function (ä 167).
• The DENSITY (EXTERNAL) option only appears if DENSITY or DENSITY 72 was
selected in the HART INPUT function (ä 167).
Options
OFF
VOLUME FLOW
VOLUME FLOW IN %
BARGRAPH VOLUME FLOW IN %
TEMPERATURE
CALCULATED SATURATED STEAM PRESSURE
TOTALIZER 1
TOTALIZER 2
TAG NAME
OPERATING/SYSTEM CONDITIONS
MASS FLOW
MASS FLOW IN %
BARGRAPH MASS FLOW IN %
CORRECTED VOLUME FLOW
CORRECTED VOLUME FLOW IN %
BARGRAPH CORRECTED VOLUME FLOW IN %
HEAT FLOW
HEAT FLOW IN %
BARGRAPH HEAT FLOW IN %
VELOCITY
VELOCITY IN %
BARGRAPH VELOCITY IN %
TEMPERATURE (EXTERNAL)
PRESSURE (EXTERNAL)
DENSITY (EXTERNAL)
Factory setting
TEMPERATURE
100%-VALUE LINE 1 Prerequisite
The function is only available if one of the following options was selected in the ASSIGN
LINE 1 function (ä 112):
• VOLUME FLOW IN %
•MASS FLOW IN %
• CORRECTED VOLUME FLOW IN %
• HEAT FLOW IN %
Description
Use this function to enter the flow value which should be shown on the display as
the 100% value.
If a value was specified for the VALUE 20 mA function (ä 120) when ordering, this
value is also used here as the factory setting.
User input
5-digit floating-point number
Factory setting
10 l/s (for volume flow)
10 kg/h (for mass flow)
10 Nm³/h (for corrected volume flow)
10 kW (for heat flow)
Function description, USER INTERFACE group