What to do if Endress+Hauser Accessories show measure simulation?
If your Endress+Hauser Accessories indicate a measure simulation is running, it signifies that the device is not currently measuring. To resume normal operation, end the simulation.
What to do if my Endress+Hauser Laser Level measures incorrectly?
If your Endress+Hauser Laser Level measures incorrectly, check and correct the parameter configuration.
What causes F283 error on Endress+Hauser Laser Level and how to fix it?
If you encounter the error code F283 on your Endress+Hauser Laser Level, it could be due to a defective main electronics, electromagnetic effects exceeding specifications, disconnected supply voltage during writing, or an error during writing. In any of these cases, perform a reset of the device.
What does error F411 on Endress+Hauser Laser Level mean and how to resolve it?
If you are getting error code F411 on your Endress+Hauser Laser Level, it indicates that the file is defective or that data was not correctly transmitted during the download. Try repeating the download, or using another file.
How to fix C824 error on Endress+Hauser Laser Level?
If you encounter the error code C824 on your Endress+Hauser Laser Level, check the pressure value and restart the device.
What does error C482 mean on Endress+Hauser Laser Level and how can I fix it?
If you are getting error C482 on your Endress+Hauser Laser Level, end the simulation.
What does error code F841 signify on an Endress+Hauser Laser Level?
If you see error code F841 on your Endress+Hauser Laser Level, check the pressure value.
What to do if I see error F261 on my Endress+Hauser Laser Level?
If you are encountering error F261 on your Endress+Hauser Laser Level, restart the device.
What to do if Endress+Hauser Accessories show error simulation?
If your Endress+Hauser Accessories display an error simulation, it means the fault state simulation is active, and the device isn't currently measuring. To fix this, end the simulation.
What to do if Endress+Hauser Accessories show process pressure errors?
If you encounter process pressure errors with your Endress+Hauser Accessories, it indicates an overpressure or low pressure situation, or electromagnetic effects exceeding technical specifications. Try the following: 1. Check the pressure value. 2. Restart the device. 3. Perform a reset.
General| Device Type | Hydrostatic level measurement |
|---|---|
| Output Signal | 4 to 20 mA |
| Protection Class | IP68 |
| Application | Water and wastewater |
| Power Supply | 10 to 30 V DC |
| Process Temperature | -10 to +70 °C (14 to 158 °F) |
| Material | Stainless steel |
| Housing Material | 316L |
| Sensor Material | Stainless steel |
| Cable Material | PUR |
| Approvals | ATEX, IECEx, CSA, FM |
To Next Page
