Endress+Hauser Waterpilot FMX21 - Overview of the Operating Menu

Overview of the operating menu Waterpilot FMX21
72 Endress+Hauser
13 Overview of the operating menu
Depending on the parameter configuration, not all submenus and parameters are
available. Information on this can be found in the parameter description under
"Prerequisite".
Setup Description
Mode →  83
Press. eng. unit →  85
Corrected press. →  87
Pos. zero adjust (relative pressure sensor) →  84
Calib. offset (absolute pressure sensor) →  84
Empty calib. ("Level" measuring mode and "Calibration mode" = wet) →  89
Full calib. ("Level" measuring mode and "Calibration mode" = wet") →  90
Set LRV ("Pressure" measuring mode) →  86
Set URV ("Pressure" measuring mode) →  86
Damping →  84
Level before Lin ("Level" measuring mode) →  92
Press after damping →  87
Setup → Extended setup Description
Code definition →  80
Device tag →  81
Operator code →  80
Setup → Extended setup → Level
("Level" measuring mode)
Description
Level selection →  88
Output unit →  88
Height unit →  88
Calibration mode →  89
Empty calib. →  89
Empty pressure →  89
Empty height →  90
Full calib. →  90
Full pressure →  90
Full height →  91
Adjust density →  91
Process density →  92
Level before lin →  92
Setup → Extended setup → Linearization Description
Lin. mode →  93
Unit after lin. →  93
Line-numb: →  93