Endress+Hauser Waterpilot FMX21 - Expert → Measurement → Level

Description of device parameters Waterpilot FMX21
88 Endress+Hauser
14.7 Expert → Measurement → Level
Level selection
Write permission Operators/Service engineers/Expert
Description Select the method for calculating the level
Options • In pressure
If this option is selected, specify two pressure/level value pairs. The level value is
displayed directly in the unit that you select via the "Output unit" parameter.
• In height
If this option is selected, specify two height/level value pairs. From the measured
pressure, the device first calculates the height using the density. Along with the two
value pairs specified, this information is then used to calculate the level in the "Output
unit" selected.
Factory setting In pressure
Output unit
Description Select the unit for the measured value display for the level before linearization.
Note The selected unit is used only to describe the measured value i.e. when a new output unit
is selected, the measured value is not converted.
Example • Current measured value: 0.3 ft
• New output unit: m
• New measured value: 0.3 m
Options • %
• mm, cm, dm, m
• ft, inch
• m
3
, in
3
• l, hl
• ft
3
• gal, Igal
• kg, t
• lb
Factory setting %
Height unit
Write permission Operators/Service engineers/Expert