What to do if Endress+Hauser Accessories show current simulation?
If your Endress+Hauser Accessories indicate a current simulation is active, it means the current output simulation is enabled, preventing the device from taking measurements. To resolve this, end the simulation.
What to do if Endress+Hauser Accessories show error simulation?
If your Endress+Hauser Accessories display an error simulation, it means the fault state simulation is active, and the device isn't currently measuring. To fix this, end the simulation.
What to do if Endress+Hauser Accessories show measure simulation?
If your Endress+Hauser Accessories indicate a measure simulation is running, it signifies that the device is not currently measuring. To resume normal operation, end the simulation.
Why is HART communication not working on my Endress+Hauser Laser Level?
If HART communication is not working on your Endress+Hauser Laser Level, ensure the communication resistor (250 ?) is correctly installed. Also, verify that the Commubox is properly connected and that the Commubox selector switch is set to 'HART'.
What causes output current < 3.6 mA on Endress+Hauser Laser Level?
If the output current is less than 3.6 mA on your Endress+Hauser Laser Level, check the wiring of the signal line. The electronics unit may also be defective, so check the wiring.
General| Device Type | Hydrostatic level measurement |
|---|---|
| Output Signal | 4 to 20 mA |
| Protection Class | IP68 |
| Application | Water and wastewater |
| Power Supply | 10 to 30 V DC |
| Process Temperature | -10 to +70 °C (14 to 158 °F) |
| Material | Stainless steel |
| Housing Material | 316L |
| Sensor Material | Stainless steel |
| Cable Material | PUR |
| Approvals | ATEX, IECEx, CSA, FM |
To Next Page
