Endress+Hauser Waterpilot FMX21 - Page 117

Waterpilot FMX21 Description of device parameters
Endress+Hauser 117
Prerequisite "Measuring mode" = Level and "Simulation mode" = Level
Value at switch-on Current level measured value
Sim. tank cont.
Write permission Operators/Service engineers/Expert
Description Enter the simulation value. See also "Simulation mode".
Prerequisite "Measuring Mode" = level, Lin mode "Activate table" and "Simulation Mode" = Tank content
Value at switch-on Current tank content
Sim. current
Write permission Operators/Service engineers/Expert
Description Enter the simulation value. See also "Simulation mode".
Prerequisite "Simulation Mode" = Current value
Value at switch-on Current current value
Sim. alarm/warning
Write permission Operators/Service engineers/Expert
Description Enter the simulation value. See also "Simulation mode".
Prerequisite "Simulation Mode" = Alarm/Warning
Factory setting: 484 (Simulation active)