Enerpac JS125 - Page 78

www.enerpac.com
Document number: ED.03783.00.001.ENG rev 4 Page 78 of 153
To activate the Calibration mode.
The password is 5678.
The Calibration mode is logged out automatically when you
end calibration.
To switch off all safety measures of the system.
All other functionality in this mode is equal to normal
operation.
The password is 5678
To show a graph on which the COG of all certain unit are
presented.
The graph is shown on the Unit-data area of the main screen.
To show a graph on which the COG of the complete system is
presented, together with the positions of the units.
The version of the application software