Enerpac JS125 - Page 91

www.enerpac.com
Document number: ED.03783.00.001.ENG rev 4 Page 91 of 153
Sensor type
By default the correct sensor type is chosen.
Change if the sensor type was changed.
Insert configuration
No functionality is implemented for this function; sorry … ☺
Units
The units in which all values are presented on the HMI can be chosen.
Use this window to set your preferences.
Position
Positions are displayed in
- millimetres
- inches
Pressure
Pressures are displayed in
- Bar
- Psi
Load
Loads are displayed in:
- KN = kilo newton
- Sh Tn = Short tons
- Kips = kilo pascal