EnGenius ESR300 - Configuring L2 TP

57
Conguring L2TP
L2TP (Layer 2 Tunneling Protocol) is used in association with
VPNs (Virtual Private Networks). There are two parts to a L2TP
connection:
1. The WAN interface settings
and
2. The L2TP settings.
To view the L2TP settings, click Internet, then click L2TP.
WAN Interface Settings
Dynamic IP Address
WAN Interface Type
Select Dynamic IP Address to assign an IP address provided by an
ISP.
Hostname
Enter a host name of an ISP (optional).
Clone MAC
Enter the MAC address of your computer’s embedded Network
Interface Card (NIC) in the MAC address eld and click Clone MAC.
Note: Some ISP providers require registering the MAC address
of the network interface card (NIC) connected directly to
the cable or DSL modem. Clone MAC masks the router’s MAC
address with the MAC address of the computer’s NIC.