Section 5 — Storage
ENSONIQ DP/4+ Reference Manual 7
Copying Presets
The DP/4+ can also copy presets to other RAM locations.
To Copy a Preset
1. Press {SELECT} (the Select LED should be on).
2. Press the {COPY} button. The top line of the display shows one of four possible screens:
Copy to 1U Pset Copy to 4U Pset
This shows that you are copying a 1 Unit Preset. This shows that you are copying a 4 Unit Preset.
Copy to 2U Pset Copy to Config
This shows that you are copying a 2 Unit Preset. This shows that you are copying a Config Preset.
The screen that appears and the type of preset that will be copied is determined by the
current config and the unit that is active when you press {COPY}. The rules which govern
this are the same as in Select mode. You can copy what you have most recently selected in
the current config.
3. Press {CANCEL} if you wish to exit from the copy procedure and return to Select mode. This
may be necessary if the preset type is not what you expected to copy. Make sure that the
Config LED is not on unless you wish to copy a config preset.
4. Use the Data Entry Knob to choose a new location (preset numbers 00 through 49) to copy
your preset. The LED numeric display shows the destination number for your preset.
5. Press the {COPY} button a second time to copy your preset. The display will momentarily
show the same “*WRITE OK*” message that appears when saving a preset from Edit mode
(see earlier).
6. You have just successfully copied your preset.
To Next Page
Loading...
Need help?
General
