ENSONIQ DP/4+ User Manual

Section 2 — Algorithms
46 ENSONIQ DP/4+ Reference Manual
11 — Noise Gate Off Below Range: -96 to +00 dB
Sets the lower threshold level at which the noise gate shuts off the audio.
12 — Noise Gate On Above Range: -96 to +00 dB
Sets the upper threshold level at which the noise gate passes the audio. The higher second
threshold prevents false “turn ons.”
13 — Gate Release Time Range: 1ms to 10.0s
This parameter sets the amount of time after the signal has elapsed for the noise gate to shut
down. For a longer sustain, set this parameter higher.
14 — Speaker High Pass Cutoff Range: 4 to 1000 Hz
This parameter filters out the low frequencies of the main amp prior to the speaker. The higher
the value, the less low frequencies pass through.
15 — OutEQ1 Fc Range: 100 to 9999 Hz
This parameter determines the filter center frequency of the parametric in the main amp stage.
Higher values have a brighter sound.
16 — OutEQ1 Gain Range: -48 to +24 dB
This parameter adjusts the amount of boost or cut applied to the main amp parametric.
17 — OutEQ1 Q Range: 01 to 18
Determines the width of the resonant peak of the filter center. While the Filter center parameter
determines where (at what frequency) this peak will occur, the Q setting controls the presence of
the peak.
18 — OutEQ2 Fc Range: 100 to 9999 Hz
This parameter determines the filter center frequency of the second parametric in the main amp
stage. Higher values have a brighter sound.
19 — OutEQ2 Gain Range: -48 to +24 dB
This parameter adjusts the amount of boost or cut applied to the second main amp parametric.
20 — OutEQ2 Q Range: 01 to 18
This parameter determines the width of the resonant peak of the second filter center.
21 — Speaker Low Pass Cutoff Range: 2.0 to 16.0 KHz
Filters out the high frequencies of the speaker. The lower the value, the less high frequencies
pass through. This speaker filter is less selective than the speaker cabinet emulation algorithms.
22 — Mod1 Source 26 — Mod2 Source
23 — Mod1 Destination 27 — Mod2 Destination
24 — Mod1 Param Range Min 28 — Mod2 Param Range Min
25 — Mod1 Param Range Max29 — Mod2 Param Range Max
See the descriptions under the Algorithm Modulators earlier in this section.

ENSONIQ DP/4+ Specifications

General

Brand	ENSONIQ
Model	DP/4+
Category	Recording Equipment
Language	English