EasyManuals Logo

ENSONIQ DP/4+ User Manual

ENSONIQ DP/4+
199 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
Section 2 — Algorithms
48 ENSONIQ DP/4+ Reference Manual
13 — Noise Gate On Above Range: -96 to +00 dB
Sets the upper threshold level at which the noise gate passes audio. This higher second threshold
prevents false “turn ons.”
14 — Gate Release Time Range: 1ms to 10.0s
Sets the amount of time after the signal has elapsed for the noise gate to shut down. For a longer
sustain, set this parameter higher.
15 — Speaker High Pass Cutoff Range: 4 to 1000 Hz
Filters out the low frequencies of the main amp prior to the speaker. The higher the value, the
less low frequencies pass through.
16 — OutEQ1 Fc Range: 100 to 9999 Hz
Determines the filter center frequency of the parametric in the main amp stage. Higher values
have a brighter sound.
17 — OutEQ1 Gain Range: -48 to +24 dB
This parameter adjusts the amount of boost or cut applied to the main amp parametric.
18 — OutEQ1 Q Range: 01 to 18
Determines the width of the resonant peak at the filter center. While the Filter center parameter
determines where (at what frequency) this peak will occur, the Q setting controls the presence of
the peak. This parameter is equal to the cutoff frequency divided by the bandwidth.
19 — OutEQ2 Fc Range: 100 to 9999 Hz
Determines the filter center frequency of the second parametric in the main amp stage. Higher
values have a brighter sound.
20 — OutEQ2 Gain Range: -48 to +24 dB
Adjusts the amount of boost or cut applied to the second main amp parametric.
21 — OutEQ2 Q Range: 01 to 18
Determines the width of the resonant peak of the second filter center.
22 — Speaker Low Pass Cutoff Range: 2.0 to 16.0 KHz
This parameter filters out the high frequencies of the speaker. The lower the value, the less high
frequencies pass through. True speaker emulations are provided as separate algorithms.
23 — Mod1 Source 27 — Mod2 Source
24 — Mod1 Destination 28 — Mod2 Destination
25 — Mod1 Param Range Min 29 — Mod2 Param Range Min
26 — Mod1 Param Range Max30 — Mod2 Param Range Max
See the descriptions under the Algorithm Modulators in the beginning of this section.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ENSONIQ DP/4+ and is the answer not in the manual?

ENSONIQ DP/4+ Specifications

General IconGeneral
BrandENSONIQ
ModelDP/4+
CategoryRecording Equipment
LanguageEnglish

Related product manuals