ENSONIQ DP/4+ User Manual

Section 2 — Algorithms
50 ENSONIQ DP/4+ Reference Manual
11 — Pre-EQ Gain Range: -48 to +24 dB
Adjusts the amount of boost or cut applied to the parametric filter in front of the preamp.
12 — Pre-EQ Q Range: 01 to 18
Determines the width of the resonant peak at the parametric filter center frequency. While the
Filter center parameter determines where (at what frequency) this peak will occur, the Q setting
controls the presence of the peak.
13 — Noise Gate Off Below Range: -96 to +00 dB
Sets the lower threshold level at which the noise gate shuts off the audio. This parameter also
automatically sets the noise gate to turn back on at 6 dB higher than the defined range, thus
preventing hysteresis.
14 — Gate Release Time Range: 1ms to 10.0s
This parameter sets the amount of time after the signal has elapsed for the noise gate to shut
down. For a longer sustain, set this parameter higher.
15 — Speaker HighPass Cutoff Range: 4 to 1000 Hz
This parameter filters out the low frequencies of the main amp prior to the speaker. The higher
the value, the less low frequencies pass through.
16 — OutEQ1 Fc Range: 5 to 9999 Hz
This parameter determines the filter center frequency of the parametric in the main amp stage.
Higher values have a brighter sound.
17 — OutEQ1 Gain Range: -48 to +24 dB
This parameter adjusts the amount of boost or cut applied to the main amp parametric.
18 — OutEQ1 Q Range: 01 to 18
Determines the width of the resonant peak of the filter center. While the Filter center parameter
determines where (at what frequency) this peak will occur, the Q setting controls the presence of
the peak.
19 — OutEQ2 Fc Range: 5 to 9999 Hz
This parameter determines the filter center frequency of the second parametric in the main amp
stage. Higher values have a brighter sound.
20 — OutEQ2 Gain Range: -48 to +24 dB
This parameter adjusts the amount of boost or cut applied to the second main amp parametric.
21 — OutEQ2 Q Range: 01 to 18
This parameter determines the width of the resonant peak of the second filter center.
22 — Speaker Low Pass Cutoff Range: 2.0 to 16.0 KHz
The parameter acts like a speaker, and filters out the high frequencies of the guitar signal. The
lower the value, the less high frequencies pass through. This speaker filter is less selective than
the speaker cabinet emulation algorithms.
23 — Mod1 Source 27 — Mod2 Source
24 — Mod1 Destination 28 — Mod2 Destination
25 — Mod1 Param Range Min 29 — Mod2 Param Range Min
26 — Mod1 Param Range Max30 — Mod2 Param Range Max
See the descriptions under the Algorithm Modulators earlier in this section.

ENSONIQ DP/4+ Specifications

General

Brand	ENSONIQ
Model	DP/4+
Category	Recording Equipment
Language	English