Section 2 — Algorithms
68 ENSONIQ DP/4+ Reference Manual
16 — NonLin Density 1 Range: 00 to 99
Density 1 controls the number of echoes.
17 — NonLin Density 2 Range: 00 to 99
Density 2 controls the number of echoes in a lower frequency range. In general, to get the
smoothest sound, Density 2 is usually less than the value of Density 1.
18 — NonLin Primary Send Range: -99 to +99
Controls the level of the diffused input signal which is nearly instantaneous with respect to the
input. This signal is injected directly into the Density at the specified level.
19 — Reflection 1 Time Non Lin 1, 3 Range: 0 to 600 ms
Non Lin 2 Range: 0 to 85 ms
Controls the amount of time it takes for the first pre-echo to be injected into the Density. Pre-
echoes are the sounds which have been reflected back from the walls or other reflective surfaces.
20 — Reflection 1 Send Range: -99 to +99
This parameter controls the level of the first pre-echo.
21 — Reflection 2 Time Non Lin 1, 3 Range: 0 to 600 ms
Non Lin 2 Range: 0 to 85 ms
This controls the amount of time it takes for the second pre-echo to be injected into the Density.
22 — Reflection 2 Send Range: -99 to +99
This parameter controls the level of the second pre-echo. Experiment with both positive and
negative on all echoes to change the tonal character of the results.
23 — Left/Right Balance Range: -99 to +99
Controls the left/right stereo balance of the reverb signal. A setting of -99 would offer hard left,
whereas a setting of +99 would offer hard right. A setting of +00 would place the reverb in the
center of the stereo spectrum.
24 — Mod1 Source 28 — Mod2 Source
25 — Mod1 Destination 29 — Mod2 Destination
26 — Mod1 Param Range Min 30 — Mod2 Param Range Min
27 — Mod1 Param Range Max31 — Mod2 Param Range Max
See the descriptions under the Algorithm Modulators earlier in this section.
To Next Page
Loading...
Need help?
General
