Enterasys SecureStack C2 C2G170-24

SecureStack C2 Installation Guide xiii
About This Guide
Thisguideprovidesanoverview,installationandtroubleshootinginstructions,and
specificationsfortheEnterasys
®
SecureStackC2G170‐24stackableGigabitswitch.
Forinformationab outtheCommandLineInterface(CLI)setofcommandsusedto
configureandmanagetheswitch,refertotheEnterasys Networks
®
SecureStackC2
ConfigurationGuide.
Who Should Use This Guide
Thisguideisintendedfor anetworkadministratorresponsibleforinstallingandsetting
upthestackableswitch.
Note: In this guide, the following terms are used:
• Switch refers to a C2G170-24,unless otherwise noted.
• XSP refers to optional small-form pluggable interface modules that plug into the front
panel port slots 25 and 26.
Important Notice
Depending on the firmware version used in the C2G170-24 switch, some features described in this
document may not be supported. Refer to the Release Notes shipped with the switch to determine
which features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.