Enterasys SecureStack C2 C2G170-24 Hardware Installation Guide

Management
1-4 Introduction
Management
Managementofthemodulecanbeeitherin‐bandorout‐of‐band.In‐bandremote
managementispossibleusingTelnet,EnterasysNetworks’NetSight
®
management
application,ortheWebViewapplication.Out‐of‐bandmanagementisprovidedthrough
theDB9consoleportonthefrontpanelusingaVT100terminaloraVT10 0terminal
emulator.
Switch Configuration Using WebView
EnterasysNetworks’HTTP‐basedWebmanagementapplication(WebView)isan
intuitivewebtoolforsimplemanagementtasks.
Switch Configuration Using CLI Commands
TheCLIcommandsenableyoutoperformmorecompleteswitchconfiguration
managementtasks.
ForCLIcommandsetinformationandhowtoconfigurethemodule,refertothe
SecureStackC2 ConfigurationGuide.
Standards Compatibility
TheswitchesarefullycompliantwiththeIEEE802.3‐2002,802.3ae‐2002,802.1D‐1998,and
802.1Q‐1998standards.TheswitchesprovideIEEE802.1D‐1998SpanningTreeAlgorithm
(STA)supporttoenhancetheoverallreliabilityofthenetworkandprotectagainst“loop”
conditions.
MGBIC-MT01 Provides one 1000BASE-SX compliant LC fiber-optic multimode port with a
standard MT-RJ connector. For optical and operating range specifications,
refer to “MGBIC-LC01/MGBIC-MT01 Specifications (1000BASE-SX)” on
page A-3.
MGBIC-08 Provides one 1000BASE-ELX compliant LC fiber-optic single-mode port with a
standard LC connector. For optical and operating range specifications, refer to
“MGBIC-08 Specifications (1000BASE-ELX)” on page A-5.
MGBIC-02 Provides one RJ45 copper connection that is compliant with the 1000BASE-T
standard RJ45 connector. For specifications, refer to “MGBIC-02
Specifications (1000BASE-T)” on page A-5
Table 1-1 Description of Mini-GBICs (continued)
Mini-GBIC Specification

Enterasys SecureStack C2 C2G170-24 Specifications

General

Brand	Enterasys
Model	SecureStack C2 C2G170-24
Category	Switch
Language	English