SecureStack C2 Installation Guide 3-1
3
Hardware Installation
Thischapterprovidesinstructionstoinstallthe C2G170‐24.Followtheorderofthe
sectionslistedbelowtocorrectlyinstalltheswitch.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the switch to check for any exceptions to the supported
features and operation documented in this guide.
For information about... Refer to page...
Required Tools 3-2
Unpacking the Switch 3-2
Considerations Prior to Installation 3-2
Installing Optional Mini-GBICs 3-3
Installing the Switch on a Flat Surface 3-7
Connecting High-Speed Stacking Cables 3-11
Configuring Switches in a Stack 3-12
Connecting AC and RPS Power 3-15
Connecting to Console Port for Local Management 3-17
Connecting to the Network 3-22
Completing the Installation 3-30
To Next Page
Loading...
Need help?
General