Enterasys SecureStack C2 C2G170-24

Using the Password Reset Switch
SecureStack C2 Installation Guide 4-7
Using the Password Reset Switch
Ifyouforgettheswitchloginpassword,usethePasswordResetswitchasdescribedinthe
followingprocedure.
Figure 4-3 Password Reset Switch
Toresettheswitchpassword,refertoFigure 4‐3andproceedasfollows:
1. Press‐and‐holdtheResetbuttonwhiletheswitchisoperational.Thischangeofthe
loginpasswordtothedefault
passwordwillbeindicatedviaCLIonly.
2. Logontodevicemanagement.YoucannowlogontotheswitchviatheConsoleport
andassignanewpasswordusingthecommandlineinterface(CLI).
3. ToaccessswitchmanagementfromyourlocalPC,terminal,ormodemconnection,
refertotheSecureStackC2Configuration
Guideforinstructionsonhowtologinand
enteranewpassword.Theguideisavailableonlineat:
http://www.enterasys.com /support/manuals
Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribed
in“GettingHelp”onpage 1‐5.
1 Password Reset switch
Note: Notify the system manager before changing the password.
STACK UP
STACK DOWN
À