Envision One cDLM® User Manual
TS-MAM-EnvisionOneCDLMUserManual-V5.0-FN-EN , 2021-12-15
→ The following screen appears.
Make sure your material tray does not contain material in it. Material residue in the material tray
during the calibration will give a false reading to the sensors.
3. Tap [OK].
→ The platform starts moving to its Dry position.
→ Once the platform finds its Dry position, it starts moving to Zero position.
→ Dry position calibration has been saved.
→ The following screen appears.
9.1.1.1 Adding new material tray
If you want to add new material tray to the list, proceed as follows:
Tap Settings | Move & Calibration | Home Calibration | Auto Homing | Add New Material Tray.
→ The following screen appears.
To Next Page
Loading...