EPSON AcuLaser C1900/AcuLaser C900 Revision B
Product Description Control Panel 51
Note *1: Not displayed when nothing is registered in Verify Job, Re-print Job, and Stored Job
*2: Displayed only when Quick Print Job menu → User=<User name> is selected
*3: Displayed only when Quick Print Job menu → Job=<Job name>is selected. After its
execution, the control returns after exiting the SelecType mode.
*4: By executing “Delete” the menu changes to “Job”. “User” is displayed when no job
is registered. When there is no “User”, quit the SelecType menu.
*5: Not displayed when nothing is registered in Confidential Job.
*6: Displayed only when ConfidentialJob menu → User=<User name> is selected.
Password is inputted by the 1(Back), 2(Up), 3(Enter) and 4(Down) buttons.
*7: Displayed only when there is a job matching the password entered after
ConfidentialJob menu → Enter Password=<password> is inputted.
*8: Displayed only when ConfidentialJob menu → Job=<Job name> is selected. After
its execution, the control returns after exiting the SelecType mode.
*9: By executing “Delete” the menu changes to “Job”. “User” is displayed when no job
is registered. When there is no “User”, quit the SelecType menu.
*10: Use this function when replacing a toner cartridge before “Replace Toner uuuu”
occurs. The selected toner cartridge moves to the replacing position.
*11: The value is reflected immediately on the Status sheet and EJL read-back, but
changed practically after a warm boot or restarting of the printer.
Table 1-37. Function Setting (3)
Menu Item Value
Quick Print Job Menu
*1
User xxxxxxxxxxxxxx
Job
*2
xxxxxxxxxxxxxxx
Copies
*3
1 ~ 999
Delete
*3,*4
ConfidentialJob Menu
*5
User xxxxxxxxxxxxxx
Enter Password
*6
XXXX
Job
*7
xxxxxxxxxxxxxxx
Copies
*8
1 ~ 999
Delete
*8, *9
Reset Menu Clear Warning
Clear All Warnings
Reset
Reset All
SelecType Init
Change Toner C
*10
Change Toner M
*10
Change Toner Y
*10
Change Toner K
*10
Parallel Menu
*11
Parallel I/F On, Off
Speed Fast, Normal
Bi-D Nibble, ECP
, Off
Buffer Size Normal, Maximum, Minimum
USB Menu
*11
USB I/F On, Off
Buffer Size Normal, Maximum, Minimum