Epson AcuLaser C900 - Page 52

EPSON AcuLaser C1900/AcuLaser C900 Revision B
Product Description Control Panel 52
Note *1: The value is reflected immediately on the Status sheet and EJL read-back, but
changed practically after a warm boot or restarting of the printer.
*2: After the printer moves to “On Line”, The value is automatically updated to No.
*3: Displayed only when Network menu→Network Config=Yes
*4: Not displayed when Network menu→Get IPAddress=Auto
*5: Displayed only when the Type-B host interface is installed
*6: The value is reflected immediately to the Status sheet and EJL read-back, but
changed practically after a warm boot or restarting of the printer.
*7: Displayed only when Type-B Level 3 is installed. After the printer moves to “On
Line”, The value is automatically updated to No.
*8: Displayed only when Type-B Level 3 is installed and when AUX menu→AUX
Config=Yes. The content of the setting depends on the Type-B Level 3 board setting.
The value of the setting is valid when the printer is ready to print and the network
card is started again. For this reason, when the value of the setting is changed, if
“AUX Status Sheet” of the Information menu is executed before exiting the panel
setting menu, the previous value of the setting before the change is printed.
*9: Not displayed when AUX menu → Get IPAddress=Auto
*10: Displayed only when Type-B Level 3 is installed and when AUX menu→AUX
Config=Yes
*11: Not displayed on the panel, and not included in the Status sheet either. Possible to be
set at EJL.
Table 1-38. Function Setting (4)
Menu Item Value
Network Menu
*1
Network I/F On, Off
Network Config
*2
No, Yes
Get IPAddress
*3
Panel, Auto, PING
IP
*3, *4
0.0.0.0 ~ 192.168.192.168 ~ 255.255.255.255
SM
*3
0.0.0.0 ~ 255.255.255.0 ~ 255.255.255.255
GW
*3
0.0.0.0 ~ 255.255.255.255
Buffer Size Normal, Maximum, Minimum
AUX Menu
*5, *6
AUX I/F On, Off
AUX Config
*7
No, Yes
Get IPAddress
*8
Panel, Auto, PING
IP
*8, *9
0.0.0.0 ~ 255.255.255.255
SM
*8
0.0.0.0 ~ 255.255.255.255
GW
*8
0.0.0.0 ~ 255.255.255.255
NetWare
*8
On, Off
AppleTalk
*8
On, Off
NetBEUI
*8
On, Off
AUX Init
*10
Buffer Size Normal, Maximum, Minimum
ESC/Page Menu
*11
Auto CR On, Off
Auto FF On, Off
CR Function CR
, CR+LF
LF Function CR+LF, LF
FF Function CR+FF
, FF
Error Code Ignore, Space
Avoid Error Off
, On
PGI On, Off
TriColorSpace Normal
, sRGB
CM Media Type Off, Opt1, Opt2