Epson Aculaser C9200N - Page 191

EPSON AcuLaser C9200N Revision D
DISASSEMBLY AND ASSEMBLY Main Unit Disassembly/Reassembly 191
Confidential
4. Reinstall the Stopper [7].
When reinstalling the Stopper, use care so that both ends of the Stopper will not open
but stay parallel as shown in the figure above.
Keep using the Stopper after once stretched out may cause uneven pitch or other
image troubles.
○
×
[7]
4038F2C115DA
5. Reinstall the Gear [8].
6. Connect the Connector and the Flat Cable.
 When reinstalling the Gear [8], make sure that the Claw of the Gear is fit in.
 When installing the Harness, make sure the Harness is hooked along with the
Harness guide referring to the figure above.
[8]
4038F2C116DA