Epson Aculaser C9200N - Page 217

EPSON AcuLaser C9200N Revision D
DISASSEMBLY AND ASSEMBLY Main Unit Disassembly/Reassembly 217
Confidential
2. Remove the Shoulder Screw [3] and the Screw [4].
3. Remove the Vertical Transport Assy [5] as shown in the figure above.
Since multiple Connectors [6] are connected to the backside of the Vertical Transport
Assy, do not pull it by force.
4. Remove two Connectors [6] of the backside of the Vertical Transport Assy.
[6]
[5]
[3] [4]
5. Remove two Claws [7] of both sides, and remove the Sensor cover [8].
Use care not to miss the spring [9].
6. Remove two Screws [10] and the Connector [11], and then remove the IDC sensor/1 (front
side) [12].
[10]
[11]
[12]
[7]
[8]
[9]
4038F2C171DA