Epson Aculaser C9200N - Page 218

EPSON AcuLaser C9200N Revision D
DISASSEMBLY AND ASSEMBLY Main Unit Disassembly/Reassembly 218
Confidential
7. Repeat the steps from 5 to 6 and remove the IDC sensor/2 (rear side) [13].
[13]
4038F2C173DA
Feed Roller (MP tray)
C H E C K
P O I N T
The separation roller should be replaced, whenever the feed roller is replaced.
1. Snap of the E-ring [1], and remove paper feed clutch [2].
2. Remove the Gear [3].
D3
[3]
[1]
4038F2C004DA
4038F2C005DA
[2]