Interface
The following ports are available under the cable cover.
Name Function
A
Wireless LAN unit
installation section
Install the supplied wireless LAN unit here.
s "Installing the wireless LAN unit" p.40
B
Audio1 port
• Inputs audio from equipment connected to the
Computer port.
• Inputs audio from other devices when projecting
images from the device connected to the USB-A port.
C
Computer port
Inputs image signals from a computer and component
video signals from other video sources.
D
Audio Out port
Outputs audio from the currently projected image to an
external speaker.
Name Function
E
USB-B port
• Connects the projector to a computer via the supplied
USB cable, and projects the images on the computer.
s
"Projecting with USB Display" p.48
• Connects the projector to a computer via the supplied
USB cable to use the Wireless Mouse function.
s "Using the Remote Control to Operate the
Mouse Pointer (Wireless Mouse)" p.108
• Connects the projector to a computer via the supplied
USB cable to use the Easy Interactive Pen as a mouse or
as a pen to draw on the projected screen.
s "Operating a Computer from the Projected
Screen (PC Interactive)" p.84
• By connecting the projector to the Control Pad via the
supplied USB cable, you can connect to a computer
from the Control Pad.
s
"Connecting to the Control Pad" p.41
F
Monitor Out port
Outputs analog RGB signals input from the Computer
port to an external monitor. You cannot output signals
input from other ports or component video signals.
G
LAN port
Connects a LAN cable to connect to a network.
H
HDMI port
Inputs video signals from HDMI compatible video
equipment and computers. This projector is compatible
with
HDCP
g
.
s "Connecting Equipment" p.29
I
DisplayPort
Inputs video signals from DisplayPort compatible
computers. This projector is compatible with
HDCP
g
.
J
Audio3 port
Inputs audio for the specific source set in Extended -
Audio Input Setup.
K
RS-232C port
When controlling the projector from a computer, connect
it to the computer with an RS-232C cable. This port is for
control use and should not normally be used.
s "ESC/VP21 Commands" p.127
L
Power inlet
Connects the power cord to the projector.
s "From Installation to Projection" p.46
Part Names and Functions
12
To Next Page
Loading...
