Epson EB-1410Wi - Administrator Settings Menu

Sub-menu Function
IP Address
You can input the
IP address g assigned to the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 192.0.2.x, 224.0.0.0 to 255.255.255.255 (where
x is a number from 0 to 255)
Subnet Mask
You can input the
Subnet Mask g for the projector. You can enter
a number from 0 to 255 in each field of the address. However, the
following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Ad‐
dress
You can input the IP address for the gateway for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following
Gateway addresses g cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
IP Address Dis‐
play
To prevent the IP address from being displayed on the LAN
Standby screen, set this to Off.
Administrator Settings menu
Sub-menu Function
Administrator
Password
Enter the password for the Administrator Settings menu for
network settings.
You can enter up to 16 single-byte alphanumeric characters.
If the administrator password is not set, click OK with an empty
password box.
The Administrator Password is also used for Whiteboard
settings.
s "Basic menu" p.147
Network Host
Name
Enter the projector's host name.
You can enter up to 15 single-byte alphanumeric characters.
PJLink Password
Set a password to use when you access the projector using
compatible PJLink software.
You can enter up to 32 single-byte alphanumeric characters.
s "About PJLink" p.129
List of Functions
158