Mail menu
Sub-menu Function
SMTP Server
Enter the Mail Server address. This cannot be set as the host
name.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 192.0.2.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Port Number
You can input the port number for the SMTP server. The default
value is 25. You can input numbers between 1 to 65535.
Reply to
Enter the reply email address to use when an error occurs while
sending an email. You can enter up to 64 single-byte
alphanumeric characters for the email addresses.
Default e-mail
Address
Enter the default email address used to send emails. You can
enter up to 64 single-byte alphanumeric characters for the email
addresses. Set a different address from the address set in Reply
to.
Sub-menu Function
Send a Test e-
mail
Connects to the SMTP server and sends a test email to Default
e-mail Address.
Reset menu
Returns Whiteboard Settings to the default settings.
Network Menu
When Network Protect is set to On in Password Protect, a message is
displayed and the network settings cannot be changed. Set Network Protect
to Off and then configure the network.
List of Functions
150
To Next Page
Loading...
