Epson EB-1410Wi - Other Problems; No Sound Can be Heard or the Sound Is Faint; There Is Noise in the Audio (Only When Projecting USB Display); No Sound Can be Heard or the Sound Is Faint S

Other Problems
No sound can be heard or the sound is faint
Check Remedy
Check that the audio/video cable is securely attached to both the
projector and audio source.
Disconnect the cable from the audio input port, and then reconnect the cable.
Is the projector volume set to the minimum? Adjust the volume so that sound can be heard.
s Settings - Volume p.142
s
"Adjusting the Volume" p.56
Is the volume for the computer or from the image source set to the
minimum?
Adjust the volume so that sound can be heard.
Is A/V Mute active? Press the [A/V Mute] button on the remote control to cancel A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)" p.105
Is the audio cable's specification "No resistance"? When using a commercially available audio cable, make sure it is labeled "No resistance".
Is it connected with an HDMI cable? If no audio is output when connecting via an HDMI cable, set the connected equipment to PCM output.
Is Output audio from the projector selected?
(Only when projecting USB Display)
Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then select
Output audio from the projector.
Is the correct audio input selected? Check the Audio Input from the configuration menu.
s Extended - Audio Input Setup p.144
There is noise in the audio (only when projecting USB Display)
Check Remedy
Is the volume for the computer set to minimum while the projector's
volume is set to maximum?
The audio may contain noise if the volume for the computer is set to minimum while the projector's volume is set to
maximum. Increase the volume for the computer, and decrease the volume for the projector.
Problem Solving
182