H/V-Keystone if you want to perform horizontal and vertical
correction using the [
w] and [v] buttons on the control panel.
s Settings - Keystone - H/V-Keystone p.142
a
If the [Esc] button is held down for about two seconds while
the corner selection screen from step 4 is displayed, the
following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner
corrections.
Switch to H/V-Keystone: Switches the correction method to
H/V-Keystone.
s "Settings Menu" p.142
Adjusting the Image Size
Press the [Wide] and [Tele] buttons on the control panel to adjust the size
of the projected image.
a
You can also make adjustments from the configuration menu.
s Settings - Zoom p.142
Adjusting the Position of the Image (Image Shift)
You can fine tune the position of the image without moving the projector.
a
Perform Adjust Zoom or Keystone.
s
"Adjusting the Image Size" p.54
s
"Correcting Keystone Distortion" p.51
The Image Shift screen is displayed after you have made adjustments.
b
Adjust the position of the projected image.
Adjusting Projected Images
54
To Next Page
Loading...
