Make sure you perform pen calibration when using the Easy Interactive Pen
for the first time so that the projector recognizes the position of the pen
correctly.
Auto Calibration and Manual Calibration are also available.
a
Turn off the unused Easy Interactive Pen or move it away from the
projection screen when calibrating a pen.
Auto Calibration
This function automatically calibrates the pen.
a
Set Extended - Easy Interactive Function to Auto Calibration
from the configuration menu.
b
Adjust the focus by following the on-screen instructions.
s "Correcting the Focus" p.56
c
Select "Yes".
Use the [
] button on the remote control or control panel to select
"Yes".
d
The pattern image is projected and calibration starts.
Wait until calibration is complete.
Do not obstruct the projected light while the pattern image is being
projected.
a
• At the time of purchase, Auto Calibration is assigned to the [User]
button on the remote control. By pressing the [User] button on the
remote control, you can start from step 2 .
s "Remote Control" p.16
• If you start pen positioning using the remote control, make all
operations using the remote control. If you start pen positioning
using the Easy Interactive Pen, make all operations using the Easy
Interactive Pen.
Before Using the Interactive Function
65
To Next Page
Loading...
