Name Function
L
Remote port
Power is supplied to the Control Pad from the projector
when they are connected with the optional remote control
cable set. When connected, remote control signals are also
sent to the projector via the cable.
a
When not connected using the remote
control cable set, power is supplied by the
batteries. Remote control signals are sent
to the projector via infrared rays.
M
Remote control light-
emitting area
Outputs remote control signals.
N
Bottom cover
Open to connect a USB storage device.
O
Top cover
Open to connect cables and replace the batteries.
P
Cable cover
Open this cover when cables are wired along a wall.
Replacing the batteries for the Control Pad
If the Control Pad becomes unresponsive or inoperable after it has been
used for some time, the batteries may have reached the end of their service
life. When this happens, replace them with new batteries. Obtain two AA
size manganese or alkaline batteries. We recommend using alkaline batteries
for the Control Pad. You cannot use other batteries except for the AA size
manganese or alkaline.
Attention
Make sure you read the following manual before handling the batteries.
s Safety Instructions
a
Because power is supplied to the Control Pad when it is connected to
the projector with the remote control cable set, you do not need
batteries.
a
Remove the top cover.
Place your finger into the groove on the top cover, and then lift it up
and out.
b
Replace the old batteries with new batteries.
Part Names and Functions
24
To Next Page
Loading...
