a
Make sure you touch the center of the dot. Otherwise, it may
not be positioned correctly.
e
The dot appears at the top left first and then moves towards the
bottom right.
Repeat step 4 until all of the dots disappear.
a
• If you touch the wrong position, press the [Esc] button on the
remote control or control panel to return to the previous dot.
You cannot go back further than the previous dot.
• Press and hold the [Esc] button to cancel the calibration.
• It may take several seconds after all of the dots have
disappeared until calibration is complete.
When You Need to Calibrate the Pen
The position where you are drawing with the Easy Interactive Pen and
where the drawing is displayed may not match in the following situations.
• After performing Keystone correction.
• After adjusting the image size.
• After performing Image Shift.
• After changing the projector's position.
Calibrate the pen again if you notice any discrepancy in positioning.
Using the Pen
Check that the battery is installed, and then turn on the Easy Interactive
Pen.
s "Easy Interactive Pen" p.20
Touch the pen tip button to the screen to select an
item such as an icon.
Before Using the Interactive Function
67
To Next Page
Loading...
