Epson EB-1410Wi - Projecting images; From Installation to Projection

From Installation to Projection
This section explains the procedure for connecting the projector to a
computer via a computer cable and projecting images.
ON
a
Connect the projector to an electrical outlet with the power cord.
b
Connect the projector to the computer with the computer cable.
c
Turn on the projector.
d
Turn on the computer.
e
Change the computer's screen output.
When using a laptop computer, you need to change the screen
output from the computer.
Hold down the Fn key (function key), and press the b key.
a
• The method for changing differs depending on the computer
being used. See the documentation supplied with the
computer.
• Press the [t] button twice to turn the projector off.
If no image is projected, press the [Source Search] button on the remote
control, control panel, or the Control Pad. When there is no image signal
input, Whiteboard Mode is displayed.
s "Automatically Detect Input Signals and Change the Projected Image
(Source Search)" p.47
a
After projecting the image, adjust the image if necessary.
s "Correcting Keystone Distortion" p.51
s "Correcting the Focus" p.56
Projecting images
46