d
Select the corner to correct using the [ ], [ ], [ ], and [ ]
buttons on the remote control, or the [
w
], [
v
], [Wide], and [Tele]
buttons on the control panel, and then press the [
] button.
e
Correct the position of the corner using the [ ], [ ], [ ], and
[
] buttons on the remote control, or the [w], [v], [Wide],
and [Tele] buttons on the control panel.
When you press the [
] button, the screen shown in step 4 is
displayed.
If the message "Cannot adjust any further." is displayed while
adjusting, you cannot adjust the shape any further in the direction
indicated by the gray triangle.
f
Repeat procedures 4 and 5 as needed to adjust any remaining
corners.
g
When you are done, press the [Esc] button to exit the correction
menu.
Because Keystone was changed to Quick Corner, the corner
selection screen shown in step 4 is displayed the next time you press
the [
w] or [v] buttons on the control panel. Change Keystone to
Adjusting Projected Images
53
To Next Page
Loading...
