Sub-menu Function
IP Address
You can input the
IP address
g
assigned to the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used. 0.0.0.0,
127.x.x.x, 192.0.2.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask
You can input the
Subnet Mask
g
for the projector. You can enter
a number from 0 to 255 in each field of the address. However, the
following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Ad‐
dress
You can input the IP address for the gateway for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following
Gateway addresses
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
IP Address Dis‐
play
To prevent the IP address from being displayed on the LAN
Standby screen, set this to Off.
Region Code
This is a specific string of the wireless LAN module.
Search Access Point screen
Detected access points are displayed in a list.
Sub-menu Function
Refresh
Searches for the access point again.
Indicates an already set access point.
Indicates the access points where security is set.
If you select an access point where security has not been set, the
Wireless LAN menu is displayed.
If you select an access point where security has been set, the
Security menu is displayed. Select a type of security according to
the security settings for the access point.
List of Functions
154
To Next Page
Loading...
