Sub-menu Function
Self-signed Cer‐
tificate
(This item can only be set when Secure HTTP is set to On.)
The Issued to, Issued by, and Validity period information for
the certificate maintained by the server function in the projector
is displayed. This information is not displayed if Web Server
Certificate is set.
Select Refresh to update the self-signed certificate.
Web Server Cer‐
tificate
(This item can only be set when Secure HTTP is set to On.)
The Issued to, Issued by, and Validity period information on
the certificate set in the projector is displayed. This information
is not displayed when a Self-signed Certificate is set.
Select Clear to delete the stored certificate.
a
• Web Control is used to set certificates.
s "Setting Certificates" p.125
• You can also install digital certificates on the projector from a USB
storage device. However, if you install a certificate from both a USB
storage device and the network, it may not be installed correctly.
SNMP menu
Sub-menu Function
SNMP
Set to On to monitor the projector using
SNMP
g
. To monitor
the projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is Off.
Trap IP Address
1/Trap IP Ad‐
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 192.0.2.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Community
Name
Set the community name of SNMP. You can enter up to 32 single-
byte alphanumeric characters.
List of Functions
161
To Next Page
Loading...
