2.
Open the front paper guide and remove it by grasping the fins
on both sides and pulling it straight out of the printer.
Note:
When loading multipart forms that are bound on only one side by
line gluing, always use the rear push tractor. This type
of form
cannot be fed from the front push tractor.
3.
Push the tractor into the printer’s mounting slot as shown below.
You are now ready to load continuous paper with the front
push tractor.
To remove the tractor unit, press its lock tabs, tilt it forward, and
lift it out of the printer.
2-10 Paper Handling
To Next Page
Loading...
Need help?
General
