Using the pull tractor position
Before installing the tractor in the top position, you need to
remove it from its current position (front) by pressing the tractor’s
lock tabs while you lift it off the printer.
1.
Make sure the printer is turned off.
2. Lift the printer cover and paper guide up and off the printer.
3.
Grasp both ends of the clear plastic paper-tension unit, raise the
front of the unit, and lift it off the printer.
Note:
Check the paper thickness lever position to ensure that it wasn’t moved
during pull tractor installation. See ‘Adjusting the paper thickness
lever” later in this chapter for the correct lever position.
Warning:
Never move the print
head while the printer is turned on; this can
damage the printer. Also, if you just used the printer, the print
head may be hot. Let it cool for a few minutes before touching it.
Paper Handling 2-11
To Next Page
Loading...
Need help?
General
