5. Slide the left sprocket to the left margin of the paper using the
scale at the rear of the tractor as a guide. (Printing starts at the
“0” mark. See the Appendix for more information on the left
margin position.) Then slide the right sprocket to match the
width of your paper, but do not lock it.
6. Make sure your paper has a clean, straight edge. Open the
sprocket covers and insert paper from either the top, rear, or
bottom paper slot. Then fit the holes of the paper over the
tractor pins.
7.
Close the sprocket covers.
8.
Slide the right sprocket to remove any slack in the paper; then
lock it in place.
2-20 Paper Handling
To Next Page
Loading...
Need help?
General
