9. Attach the printer cover and paper guide.
Note:
Advance the paper behind the printer guide as shown below. Make
sure the paper path guide rests against the paper guide.
10.
Slide the left and right edge guides to the center of the paper
guide.
11. Turn on the printer. When the printer receives data, it
automatically loads the paper before printing.
Note:
Always dose the printer cover before printing. The printer stops
printing when the cover is open.
You can also advance the paper to the loading position by
pressing the
Load/Eject
button.
Caution:
Do
not use the knob on the right side of the printer except to clear
paper jams when the printer is off. Otherwise, you may damage
the printer or cause it to lose the top-of-form position.
Paper Handling 2-21
To Next Page
Loading...
Need help?
General
