Epson L18050 Series - Paper Feeds at a Slant

The installation location is inappropriate.
Solutions
Place the printer on a at surface and operate in the recommended environmental conditions.
& “Environmental Specications” on page 154
Unsupported paper is being used.
Solutions
Use paper supported by this printer.
& “Available Paper and Capacities” on page 142
& “Unavailable Paper Types” on page 144
Paper handling is inappropriate.
Solutions
Follow paper handling precautions.
& “Paper Handling Precautions” on page 25
Too many sheets are loaded in the printer.
Solutions
Do not load more than the maximum number of sheets specied for the paper.
& “Available Paper and Capacities” on page 142
Paper slips when paper dust adheres to the roller.
Solutions
If the paper you have been using until now does not feed properly, paper dust may be stuck to the roller.
Clean the roller.
If paper does not feed even aer cleaning the roller, replace the roller.
& “Cleaning the Paper Path for Paper Feeding Problems” on page 59
& “It is Time to Replace the Pickup Rollers” on page 132
Paper Feeds at a Slant
e following causes can be considered.
The paper is loaded incorrectly.
Solutions
Load paper in the correct direction, and slide the edge guide against the edge of the paper.
& “Loading Paper in the Rear Paper Feeder” on page 27
Solving Problems > Paper Does Not Feed Properly
107